- This topic has 0 replies, 1 voice, and was last updated 3 years, 5 months ago by
gordonbullock135@hotmail.com.
Viewing 1 post (of 1 total)
-
AuthorPosts
-
November 7, 2017 at 11:24 am #5759
gordonbullock135@hotmail.com
ParticipantThe BATTERY current of my Crumble is about 6ma when the usb lead isn’t connected to my computer. No LEDs are lit up, not even on the Crumble board, and no program is running.
Is it possible to lower, or even better, eliminate this current until my program is
running after a momentary push button switch is pressed? 6ma isn’t a lot but my
Crumble will operate a device that will run 24 hrs a day. Comments and suggestions
will be gratefully received. Thanks. GB -
AuthorPosts
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.